Mon-Fri: 7AM-8PM, Sat: 8AM-6PM, Sun: 9AM-5PM Licensed & Insured [email protected] Serving Fullerton, CA

Overhead Door Opener Gear & Sprocket Replacement in Fullerton, CA

Stripped drive gears replaced so the motor moves the door again. Typical cost $125-$275.

Need Overhead Door opener gear & sprocket replacement in Fullerton, CA? We diagnose the problem, give you a price before any work starts, and finish most jobs in a single visit. Stripped drive gears replaced so the motor moves the door again. We work on Overhead Door garage door openers of every age, from older models to current lines, and carry or can source compatible parts. Overhead Door-brand openers come from the same company as Genie, the Overhead Door Corporation.

Signs you need Overhead Door opener gear & sprocket replacement

  • The motor hums or runs but the chain or belt doesn't move
  • Grinding from inside the opener
  • Plastic shavings under the motor

Common causes

  • A heavy, out-of-balance door wearing the gear
  • Age and wear on the nylon gear

Before the technician arrives

  • Check the door's balance first. A heavy door will strip a new gear too.

Still stuck? Our free symptom checker and troubleshooting wizard walk you through it step by step.

What happens during the visit

  1. Check the door's balance and springs
  2. Open the motor head and replace the gear and sprocket
  3. Grease the new gear
  4. Re-set the limits and force
  5. Test it through several cycles

Overhead Door Opener Gear & Sprocket Replacement cost in Fullerton, CA

$125-$275Typical range, parts & labor
about 1 hourTypical time on site

What moves the price:

  • Drive type: chain, belt, screw or wall-mount
  • Whether the fix is a part or a whole new opener
  • Remotes, keypads and smart accessories
  • Ceiling height and rail extensions

These are typical U.S. ranges, not a quote. You get an exact price for your door before any work starts. For a quick estimate, try the repair cost calculator.

Other Overhead Door services

Local Overhead Door opener gear & sprocket replacement for Fullerton, CA

Outages are common in California during heat waves and planned power shutoffs, which is why a battery backup on the opener matters here.

California law (SB 969) requires garage door openers sold or installed in the state since July 1, 2019 to have a battery backup, so the door still works during a power outage.

Technicians serve all of Fullerton (ZIP codes 92831, 92832, 92833, 92834, 92835 and more), plus Anaheim (2.5 mi), Placentia (3.2 mi), Brea (3.5 mi) and Buena Park (4.2 mi). Call (833) 435-8883 to book a visit in Fullerton.

Overhead Door Opener Gear & Sprocket Replacement: frequently asked questions

How much does Overhead Door opener gear & sprocket replacement cost in Fullerton, CA?

Overhead Door Opener Gear & Sprocket Replacement typically costs $125-$275 including parts and labor, and usually takes about 1 hour. The exact price depends on your door and the parts it needs, and you get it before any work starts. Call (833) 435-8883 for a quote.

Can you do Overhead Door opener gear & sprocket replacement the same day?

Often, yes. When a technician is available we can usually come the same day, and common parts are carried on the truck. Doors that won't close or have a broken spring are treated as priority calls, and emergency service is available.

Is Overhead Door opener gear & sprocket replacement covered by a warranty?

Our work comes with a 90-day labor warranty on repairs. New parts and doors also carry the manufacturer's warranty, and Overhead Door warranty terms vary by product and age. Ask for the warranty details in writing with your quote.

Are your technicians licensed and insured?

Our technicians are insured, and where California or Fullerton requires a contractor license for garage door work, the job is done under that license. You're welcome to ask for proof when you book.

Should I repair or replace my opener?

A good rule of thumb: if the repair costs more than about 50% of a replacement, or the opener is near the end of its life, replace it. Most openers last 10 to 15 years. If yours is older than that, lacks photo eyes or rolling-code security, or needs a logic board or motor, a new opener is often better value. Springs are the exception: a broken spring is always replaced, never repaired. Our free repair vs. replace calculator can help you compare.

More services

Popular Garage Door Services in Fullerton, CA

Holmes Garage Door Garage Door Panel Replacement

Dented, cracked or rusted sections replaced or repaired to match your door.

Typical $300-$900

Haas Door Commercial Garage Door Repair

Repairs for commercial sectional, overhead and service doors.

Typical $250-$1,000

Stanley Opener Circuit Board Replacement

Stanley garage door openers are no longer made. Compatible remotes and some parts are still available for older units.

Typical $175-$400

Northwest Door Garage Door Installation

New steel, insulated, wood-look and carriage-style doors, measured and professionally installed.

Typical $1,200-$4,500

Wayne Dalton Garage Door Track Repair

Wayne Dalton is part of the Overhead Door Corporation. Many Wayne Dalton doors use the TorqueMaster spring system, with the springs sealed inside the torsion tube, so spring work needs TorqueMaster parts and a different procedure.

Typical $150-$400

Allstar Opener Circuit Board Replacement

Allstar openers are no longer made. Replacement remotes and many parts are still available, and we'll tell you when replacing the opener makes more sense.

Typical $175-$400

Hörmann Garage Door Roller Replacement

Hörmann is a German manufacturer of residential and commercial doors and openers with North American operations.

Typical $150-$350

Richards-Wilcox Weather Seal Replacement

New bottom seals, threshold seals and perimeter stops to keep out water and drafts.

Typical $100-$300

Hörmann Garage Door Sensor Repair

Photo-eye sensors realigned, rewired or replaced so the door closes reliably.

Typical $100-$250

Wayne Dalton Garage Door Installation

Wayne Dalton is part of the Overhead Door Corporation. Many Wayne Dalton doors use the TorqueMaster spring system, with the springs sealed inside the torsion tube, so spring work needs TorqueMaster parts and a different procedure.

Typical $1,200-$4,500

Remote & Keypad Programming

Remotes, keypads and car buttons matched and programmed to your opener.

Typical $50-$150

Garaga Garage Door Roller Replacement

Garaga is a Canadian garage door manufacturer based in Quebec.

Typical $150-$350

Garage door stuck, noisy or broken?

Talk to a garage door technician in Fullerton, CA now. Tell us what the door is doing and we'll give you a price and an arrival window.

Call NowFree Quote